Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 70 VS 90
#1

I am looking to obtain a Philco Cathedral. I have seen a number of 70's and 90's for sale on E-Bay and elsewhere. Is the 90 that much of a better performer than the 70 that it is priced so much higher at auctions, etc? From what I have read, the 70 performs quite well and there isn't that much of a difference between the two except for two tubes.

Any insight would be helpful.

Thanks to all
#2

Hi Madghost,
There are some differences. Just glancing at the schematic the 70 volume control is in the antenna circuit. The 90 has its own 2nd detector and avc. The 70 looks to me that it doesn't. Also The volume is also controlled by changing the bias on the cathodes of two of the 24 tubes on the 70. The 90 also has two stages of audio amplification before the final output tube. The 70 uses the same tube as the 2nd detector and audio amplifaction.
I'm sure Ron and Chuck could tell you more. Both of my 90's play great. With a good antenna I pick up many stations across the dial. Sorry to say I have never listened a 70. Icon_sad

Hope this helps
Terry
#3

And there are three versions of the Mdoel 90, the origninal; Early, Mid and Late.

See the Early Cathedrals section of my site.
#4

Hi Madghost

The early 70 and early 90 (using two Type 45 output tubes) share the same front end, and neither have AVC.

The "mid" 90, the most common version with a single Type 47 output, uses AVC which makes a HUGE improvement in performance; i.e. no "blasting" as you tune across the dial, and less prone to fading.

The late 90 (push-pull 47 outputs) and late 70 both have autodyne converters, and both have AVC, so again their front ends are similar.

Both are good performers. To make a long story short, the 90 has extra amplification in its audio section. It is slightly larger than the 70. And there is just something special about it, I guess, that makes it more desirable. Icon_smile

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently 701 online users. [Complete List]
» 1 Member(s) | 700 Guest(s)
Avatar

>