Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-95 Finish
#1

Can you tell me what kind of wood the 40-95 is made of and what kind of finish it has. Thanks.
#2

Sorry for the late reply, but...the 40-95 would have walnut veneer and a medium walnut finish overall.

Assuming you mean the 40-95T table model, the bottom trim is very dark brown, nearly black. Van Dyke Brown toning lacquer from Mohawk would be a good color choice for this trim.

Beware! What appears to be veneer inlay running vertically and horizontally from the two knobs are decals (photofinish)! Once the cabinet is stripped, those are gone forever. Stewart Schooley has a method of replicating photofinish; this is discussed here.

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron. Is there a list of the Philcos that have this photofinish?
#4

Not that I know of. You can count on all of the smaller 1937 and 1938 Philco cathedrals and tombstones to have the photofinish on the entire front panel. Photofinishes are also used on some later models.

Alas, I have to work for a living, so that limits my time in compiling lists...

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2144 online users. [Complete List]
» 1 Member(s) | 2143 Guest(s)
Avatar

>