Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-62 restoration
#16

Bob, that radio chassis looks great. I wouldn't mess with it. Nice job on the "old lady", she should show a little of her age. As for the TV chassis, that looks terribly nice. I can't imagine doing that deep a teardown but then again, it looked like it had seen a lot of mouse activity. You are very talented.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#17

Thanks! That TV chassis was by far the nastiest project I've tackled so far. Under the mouse droppings, I found deep corrosion. Almost right through the chassis in areas. That's why I used primer and bondo to fill it in. The set isn't particularly valuable or anything - I just wanted to see if I could do it Icon_smile
#18

Bob,

You do really nice work. After following your You Tube videos on this same radio, it's nice to see the "book" version. I always learn something when I watch/read about your restorations.

I liked your method for fixing the cabinet break. I never would have guessed it would work so well. That radio is going to look beautiful when you're done.

Tom
#19

Thanks! I'll throw up a video on the cabinet restoration when it's a little further along.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM
Philco model 38 code 121 not receiving signal.
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM
Philco model 38 code 121 not receiving signal.
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM
Philco model 38 code 121 not receiving signal.
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM

[-]
Who's Online
There are currently no members online.

>