Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

#1

I just saw that on e-bay and since in appearance itg is exact same as 38-15 I decided to look at the sch.
So it is, give opr take, the AA5 version of 38-15.

Why woud they do both in the same year?

Just to make 38-15 cheaper?
#2

Maybe they were marketing the 38-14 to areas that still had DC power but with the ability to run on AC power as well? I don't know, just a guess. Did you notice the SW band on the 38-14 is not the same as a 38-15?

Oh, and in case you were thinking about using a 38-14 speaker in a 38-12 or 38-15, you can't...the 38-14 speaker's field coil resistance is around 3000 ohms or so (don't have a schematic in front of me so I'm guessing).

You can replace the speaker in a 38-14 with a PM speaker and safely omit the resistance as the field connects between B+ and B-. The field coil in the 38-14 is only there to excite the speaker, it does not do anything else in the radio circuitry.

--
Ron Ramirez
Ferdinand IN
#3

Ron

No I am not trying to sub the speaker; the one I have works just fine; I did not even expect it to sound so decent. After all it is not a HiFi radio, it is a small table set, but it sounds fairly good.

Yes the SW is from 2 to 8MHz and in 38-15 it is 5.5 to 19 MHz. Wonder why.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently no members online.

>