Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Philco 37-84 feet and/or back?
#1

Hi all! Can anyone please tell me what kind of "feet" the 37-84 had and if it happened to have a back? Thanks So much!
#2

Very few radios in that era had backs and the 37-84 was not one of them, if it was a 37-116 then it would have had a back. As for feet I think that it may have had short rubber feet that were tacked onto the bottom of the cabinet, some sets had thick felt pads rather then rubber ones.
Regards
Arran
#3

Don't think it had either.
Terry
#4

There was another kind that weren't really feet as such, but they were these round metal runners, about 3/8'' wide, with a felt pad crimped into the center, some were nailed on and some had a screw holding them on. If this set had those originally then they would probably still be there, they aren't the kind of thing that would just fall off.
Regards
Arran
#5

It's pretty much always OK to get a set of tack like feet with felt or rubber bottoms for a wooden cabinet radio to keep it from maring anything it is placed upon. Look carefully for tack holes where the originals might have been, if there were any. Stick on felts usually don't work out well on wooden bottom radios.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently 2335 online users. [Complete List]
» 1 Member(s) | 2334 Guest(s)
Avatar

>