Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Just acquired Philco 70
#1

I just picked up a model 70. Date on bottom of the cabinet says "Aug '31".

This is my first radio like this. It has been re-capped already I found out after taking out the chassis.

One bad tube (47 output). Has 24's not 24A's. All tubes are globe tubes, look to be pretty original, most are Philco tubes.

Cabinet in pretty good shape. I'll post pictures soon.

I did notice the tuning cap rubber grommets are shot, will replace with repros.

I did power it up on the variac, got sound, something is intermittent though, have to trace that down.

Any words of wisdom on these radios?

One more for the collection!
#2

1. Check the re-cap. Never trust anyone unless you know the person and the reputation.
2. Check the resistors.
3. Check the tubes.
4. Inspect the wiring etc.
5. See if the tone control has been re-stuffed and re-wired.
6. Power up, measure voltages.
7. If works, align.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 377 online users. [Complete List]
» 1 Member(s) | 376 Guest(s)
Avatar

>