Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 2 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pilot H220 Radio @ Flea Market
#16

That may be difficult, it the knobs it uses are of the ship's wheel style. If those are the correct knobs they were also used on a post war Pilot TV. The good news is that you can buy reproductions of that style of knob, but they are not exactly cheap.
Regards
Arran
#17

Thanks, Arran. It does have the "ship's wheel" style knob. The outer ones are correct. I will just need to find the 2 inside ones which my friend thinks he may have. We will see.

Craig R.
#18

http://www.renovatedradios.com/parts.html

About 2/3 down the page Pilot TV-37 Television Knobs (KPilotTV37)
#19

Thanks BrendaAnnD for the link! I will wait to get the radio back and compare the knobs. From the pics in the link it looks as if we may have a match (if my chassis expert doesn't have any in his collection). Thanks again. Much appreciated!

Craig R.
#20

What is interesting is that this set is an AC/DC set with a combination of tubes in series-filament and parallel filament configuration.
#21

I just picked up one of these Pilot H220 (Similar to Model 224)
I need Back Photo's and dimensions as mine is missing.
Radio Otherwise Complete. All Original Knobs. They are NOT the Ships Wheel Type as used on the TV.
E-Mail sent to original Poster

Bob T
Wilmington, NC
#22

Looks like an Airline model.
#23

Wow! A buddy in Wilmington just got a hold of the same set!!

If you want to see something interesting look at the schematic for this bear!

11 tubes plus ballast AC/DC set, FOUR 25L6 output tubes, and TWO 25Z6 rectifiers!

When you add up the total filament voltages, it is 180 volts, AND the 81973 ballast is rated at 47 volts at 300mA!!

Some serious parallel and series filament strings here!!!
#24

Ah.... just noticed my buddy made the entry a couple before me......

Just remember, kids. Work HARDER, not SMARTER !!!
#25

    [attachment=3819][attachment=3819]        

Just Acquired a Pilot H220 (Same as 224) I believe

All original except for missing Back.
Paid a LOT more than $45 though
Needs Recap , but is playing on Variac

Have contacted OP to get Photo of back and Dimensions.
Heavy HUGE Radio

Bob T




Users browsing this thread:
[-]
Recent Posts
Electrolytic restuffing/internals
I don’t have a vise so I had to hold it in my hand. Not optimal but covered up by the hvac tape in the end. I have a few...bridkarl — 11:52 PM
Electrolytic restuffing/internals
Bridkarl A question. For a hacksaw the cut looks a little...jagged. Why?morzh — 11:45 PM
The list of my radio & TV collection!
As usual, an interesting post from you, Peter. This seems to be similar to the RCA 3-BX-671 and the Zenith Transoceanic...MrFixr55 — 11:41 PM
The list of my radio & TV collection!
Hello Peter, Thank you for sharing your new video and looks like your weather is nice their too. it was like 25 Cel...radiorich — 11:05 PM
Electrolytic restuffing/internals
hello bridkarl, I will post some better photos ! Sincerely Richardradiorich — 10:14 PM
Electrolytic restuffing/internals
I just taped the two pieces of the cap together, but I can see your method is better. I just held the lead in with solde...bridkarl — 08:18 PM
Electrolytic restuffing/internals
hello bridkarl, Well done ! Here is a Photo of the base of Philco capacitor that I cut open you can see how I glued th...radiorich — 08:14 PM
philco predicta
Hi CGL18, Here is a link for the schematic from the Early television Foundation: WARNING!! One side of the Chassis i...MrFixr55 — 08:09 PM
The list of my radio & TV collection!
Peter; I like Canadian General Electric sets, whilst the model numbers are often the same as their U.S General Electr...Arran — 05:44 PM
Electrolytic restuffing/internals
Did as suggested. Cut can with hacksaw, removed internals, attached new 8mf cap - with ample use of cardboard and elec...bridkarl — 03:36 PM

[-]
Who's Online
There are currently no members online.

>