Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-841 portable: battery connector
#1

Hi, does anyone know where to obtain a battery plug for a 1941 portable? There were several similar models in years right before and after, probably all used same connector.

I have a minty 41-841 which plays extremely well. The radio half of the battery plug connector is there and in great shape. It's 5 pronged and male (as opposed to my G500 Transoceanic which is 4 pronged and female).

I don't want to cut off the old plug and substitute for it, would like to keep it in a more original configuration. Except for the plug difference the *heavy* TO pack I already have would work fine (60AAs, 6Ds). It fits right in the 41-481 compartment, and the B voltage is already correct (90v). And by removing one of the D sized A cells (and jumpering), then the filament voltage would also be correct (the 1941 radio has one less 1.4 volt tube in the string).
By the way, the TO pack easily fits in a TO but just barely squeezes into the 41-841 compartment. So, some other packs made for TO's probably would not fit.
#2

You're gonna laugh--it's an octal socket. Only difference is a pilot hole takes place of the center "keyhole".

Your set uses a P-841A battery--one that I haven't designed yet, but I have an original Burgess equivalent that I can base dimensions on.

Bill
#3

Hmm, the middle pin being offset from center is what fooled me Icon_rolleyes

If you can make a smaller/lighter pack that takes less batteries than my TO (66 cells!), then please let me know how much it would cost me up front to have you go ahead and make one, assuming you're willing and not too busy and all that...

But I only need one pack so it might not be worth your while, and maybe anyone else around here needs one for their Philco, too?
#4

I can build one, though it's going to be awhile before it's finished. I have about ten separate orders to fill...


Contact me at batterymaker@gmail.com

Bill
#5

I take what I said back.

I DO have a pattern already for a P-841. It's your garden variety Eveready 753!

Dummy here wasn't reading his list properly. I must've taken a Ritalin placebo. Icon_lol

I can do that one easily. In fact, I'm making four of them for various people. Again, though, because of the load, it'll be a bit.

Bill




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
For fans of antique radio... My new video... How to test radio tubes on a Hickok 530B tube tester? Test radio tubes o...RadioSvit — 01:25 PM
philcorepairbench.com - shadow-meter
Thank you Billpoulsbobill — 11:53 AM
philcorepairbench.com - shadow-meter
Hi, Try here Philco Service Hints & Tips, Number 1 It's from the web archive (Way Back Machine).Keith — 10:17 AM
PT-6 finished!!
Hi Arran,  Yes, you are correct, the "nominal" voltage for these Loctal tubes was the same 6.3 or 12.6 V as...MrFixr55 — 07:48 AM
PT-6 finished!!
Actually the Loctal tube series, with number beginning with "14" are 12.6 volt tubes, at 150 ma, I'm not sure ...Arran — 02:14 AM
philco predicta
The model is the holiday without UHF It has no sound and I don't have an oscilloscope or signal generator.cgl18 — 08:51 PM
Philco model 38 code 121 not receiving signal.
I will definitely check my lead length and wire dressing. Thanks for the ideas.Stormlord5500 — 08:06 PM
Philco model 38 code 121 not receiving signal.
Do make sure that you twist the 3 wires from the chassis to the transformer, and dress away from tubes, especially audio...MrFixr55 — 07:38 PM
Philco model 38 code 121 not receiving signal.
The cone unfortunately got damaged when I removed it. The glue that held the cone to the basket was sloppily applied and...Stormlord5500 — 07:12 PM
Philco model 38 code 121 not receiving signal.
So what was wrong with the original speaker? Was the cone damaged? Unless it's totally hopeless I would put it aside as ...Arran — 05:31 PM

[-]
Who's Online
There are currently no members online.

>