Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Speaker Identification
#1

I purchased a small lot today which included a Philco speaker.Appx 8 1/2 inches diagnally across the mounting holes. The output transformer is stamped 2580N and 11-34 is stamped under that. There is a red stamp on the field coil but it is very faded. It looks like K or R 22. It has a 4 pin round plug with a flat on one side and with 3 wires. Can anyone tell me the model it belongs to?
Thanks,
Henry
#2

Using the handy-dandy "Philco Speakers" Excel file available here:
http://www.philcoradio.com/phorum/showth...hp?tid=215

I find that you probably have a K-22 speaker. It has a 2580 single-ended output transformer. 1125 ohm field, rated at 65 mA current.

Intended for use with model 44B, it could also be used with a 19B, 89, or any 1932-36 Philco requiring an 1125 ohm field. You would have to replace the audio output transformer to use it with a Philco requiring a push-pull output.

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron.
Henry




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT 6 chassis screws size???
Hello bridKarl, that sounds right or maybe 8/32 . Sincerely Richardradiorich — 01:00 AM
PT 6 chassis screws size???
Have this done except for missing chassis screws. It looks like 1 inch 6/32 sheet metal screw may work but can anyone s...bridkarl — 10:32 PM
Philco model 38 code 121 not receiving signal.
Hello Stormlord, Well done on rewinding that coil it turned fairly good for your first one. Sincerely Richardradiorich — 09:12 PM
Philco model 38 code 121 not receiving signal.
Well here it is. It ain't pretty, but hopefully it'll work. I checked it with my DMM on continuity and it keeps and r...Stormlord5500 — 08:56 PM
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM

[-]
Who's Online
There are currently 800 online users. [Complete List]
» 1 Member(s) | 799 Guest(s)
Avatar

>