Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Philco 38-2 in process of restoration
#1

Where here is a link to the restoration of my Philco 38-2, still needs a lot of work but at least it looks better than it did.

http://community.webshots.com/album/471240774XGwWFD

Icon_lol
#2

Your Philco will look Phantastic when it's Phinished.

Keep these Phrequent "in progress" Photos Phlowing....



Philco #2 Guy 8)
#3

Thanks Chuck, today I worked on getting the stain that had weeped under the tape tided up. I probably paid too much initially for this radio, but in the scheme of things that has worked out with other radios but it is a nice stately looking Philco. This is the only 38-2 I have ever seen on ebay and either people think they are "butt ugly" or there are not too many out there. Started doing the sanding lacquer also so I will be sure to take some more pics along the way so that people can see that it isn't really that bad to tear into the cabinet restoration. My wife is trying to make up her mind if she wants the 38-2 or the 38-116 in the family room, I think I will swap them when I decide to get the 116's chassis restored and put it back when that is done.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2219 online users. [Complete List]
» 4 Member(s) | 2215 Guest(s)
AvatarAvatarAvatarAvatar

>