Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What type veneer for 41-280?
#1

I was looking at my sheet of walnut but it doesn't look quite the same. My sheet looks like it has more defined lines than the 41-280.

Maybe its just me Icon_smile
#2

Lets see a few pictures of what you got going on. Its ether mahogany or walnut is my guess, there is a lot of photo finish on that set which is fake wood grain and if your trying to match that you cant.
#3

Only photo finish I can tell are on the front colums.

Here is a pic of side and veneer I have. Maybe it is to close of a shot???

[Image: http://i1289.photobucket.com/albums/b519...5cqpgh.jpg]
#4

(07-09-2015, 12:15 AM)Edisla Wrote:  Only photo finish I can tell are on the front colums.

Here is a pic of side and veneer I have. Maybe it is to close of a shot???

[Image: http://i1289.photobucket.com/albums/b519...5cqpgh.jpg]

It's French Walnut, possibly quarter cut, but that's the species you need to look for.
Regards
Arran
#5

Well pooh I don't have any of that. Time to start looking.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 368 online users. [Complete List]
» 2 Member(s) | 366 Guest(s)
AvatarAvatar

>