1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
TUBE CONVERSION CHART
madghost
Junior Member
**
Posts: 34
Threads: 15
Joined: Oct 2005
City: Collegeville,PA
#1

01-01-2006, 05:40 PM
I obtained a Heathkit tube tester model IT-17. I wanted to test my Philco 41-290 tubes but the tube chart on the tube tester does not include the ones Philco uses (it has only a few of the item 7 series tubes). I tried to find a tube conversion chart that would allow me to substitue the item number for the actual tube. In other words, if I find a substitute tube number for a 7C6 on the chart, can I use the tube nomenclature of a sub to test my 7C6? Also, I have been trying to find a satisfactory tube conversion/substitution chart on the Internet, but so far no real luck in getting a complete and full listing. Any help in either of these two items would help greatly.
Thanks much!
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
TUBE CONVERSION CHART - by madghost - 01-01-2006, 05:40 PM
[No subject] - by Doug Houston - 01-01-2006, 08:01 PM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2143 online users. [Complete List]
» 1 Member(s) | 2142 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration