Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco transitone tropic model 3010-123 schematic
#1

hi every body
first...thanks for allowing me to register in the philco phorum.
i just bought a philco transitone tropic model 3010-123... and being more than 70 years old radio there
is some rust and a lot of dirt.
i looked for a schematic for it but unfortunately i could not find one.
the thing is because of the 70 years old dirt i can not read some of the resistors values and almost all the paper caps. apart from the electrolytic one which original philco.
i would be very grateful if any body can help me with that and since no schematic is available i was thinking
that may be somebody have a better shaped radio and provide me with photos of the radio that might help me to know the values of the caps. and the resistors.
there is something else....i checked radiomuseum.org. and the tubes on that web site seems to be different from what i found in the radio...in my radio the tubes are 12be6,6bj6,35w4,50c1 nad the fifth is not clear
whether its 12av6 or ????? the only visible writing is 12a...
forgive my ignorance but i'm just a hobbyist...thanks again
N.B
a photo of the radio is attached which i found on radiomuseum.org

much obliged
Aras


Attached Files Image(s)
   


Messages In This Thread
philco transitone tropic model 3010-123 schematic - by grundigman3000 - 12-25-2015, 07:58 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2164 online users. [Complete List]
» 1 Member(s) | 2163 Guest(s)
Avatar

>