Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco TV-Radio-Phono console
#12

Kirk;
  The first thing that I noticed is that the paint on the back of the safety glass appears to be lifting in several places, the shadow mask also looks a bit spotty, I would want to have a good look at the TV chassis because of this. If you knew for a fact that the picture tube was good I would say maybe $125 at most for it, of course you won't know if the flyback or the other stuff is still good. Early Philco TV sets have issues with the high voltage dropping after the set has been playing for a while, apparently it's an issue with the early Philco Phlybacks. Untested I would say up to $100, just like with radios the big combo units tend to be less collectable then the stand alone TV sets, with smaller table sets being the most popular. Bob Andersen would be the best one to ask about this.
Regards
Arran


Messages In This Thread
Philco TV-Radio-Phono console - by Jayce - 02-09-2013, 08:52 PM
RE: Philco TV-Radio-Phono console - by radiotvnut - 02-13-2013, 12:21 AM
RE: Philco TV-Radio-Phono console - by Jayce - 02-13-2013, 04:35 PM
RE: Philco TV-Radio-Phono console - by Anini - 04-13-2013, 07:49 PM
RE: Philco TV-Radio-Phono console - by codefox1 - 04-13-2013, 08:22 PM
RE: Philco TV-Radio-Phono console - by Raleigh - 04-13-2013, 11:49 PM
RE: Philco TV-Radio-Phono console - by Arran - 04-14-2013, 01:07 AM
RE: Philco TV-Radio-Phono console - by morzh - 01-06-2016, 11:33 PM
RE: Philco TV-Radio-Phono console - by Arran - 01-07-2016, 03:11 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 1348 online users. [Complete List]
» 2 Member(s) | 1346 Guest(s)
AvatarAvatar

>