[klondike98]

For some reason I always like to start by changing out the electrolytics.  This one wasn't too hard to get to.  A few paper caps to take out first and a handful of leads to disconnect.  I opened the can by rolling the blade along the raised edge until it penetrated the can, same approach as a tube cutter, slow pressure while rolling.  I'll epoxy the can back on after its up and running.  Most of the label is still there and a little glue helped fix some spots that were loose.  So here are more pics than most would want of this  

[Image: https://www.dropbox.com/s/rx8qxkyqvh66f5....jpg?raw=1][Image: https://www.dropbox.com/s/izr0oiavxdx6gh....jpg?raw=1][Image: https://www.dropbox.com/s/t51cafhj17g0uh....jpg?raw=1][Image: https://www.dropbox.com/s/00bq0ysyjemvb3....jpg?raw=1][Image: https://www.dropbox.com/s/3bhx7xel9icha5....jpg?raw=1]