philco 48-1283 wiring issue

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

philco 48-1283 wiring issue

Guest
Unregistered

04-24-2009, 05:31 PM

I'm restoring a Philco 48-1283 and having a few issues. I have the schematic ( of the 48-1262) and mods to the 1283,but there are some inconsistencies especially in the actual wiring of the 35L6GT tube. However, I basically just recapped and replaced the resistors. The unit worked before; checked only as a test, so I know the tubes and wiring must have been ok. Now, in radio mode all I get is a hum UNTIL I turn off the power, then for a short few seconds I can clearly hear an AM station. Test points A and C all read high at ~265v, but I've checked the resistors and caps as specified in the diagnoistics. Any help would be appreciated. Icon_sad

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

philco 48-1283 wiring issue - by Guest - 04-24-2009, 05:31 PM

Re: philco 48-1283 wiring issue - by planigan - 04-24-2009, 11:34 PM

Re: philco 48-1283 wiring issue - by Texasrocker - 04-25-2009, 03:52 AM

Re: philco 48-1283 wiring issue - by Guest - 04-25-2009, 10:06 AM

Re: philco 48-1283 wiring issue - by codefox1 - 04-25-2009, 01:23 PM

Re: philco 48-1283 wiring issue - by planigan - 04-25-2009, 08:12 PM

Re: philco 48-1283 wiring issue - by Guest - 04-26-2009, 12:07 AM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 01:36 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 01:52 PM

Re: philco 48-1283 wiring issue - by Guest - 04-26-2009, 04:45 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 06:47 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 11:10 PM

Re: philco 48-1283 wiring issue - by Guest - 05-03-2009, 12:43 AM

Re: philco 48-1283 phono cartridge replacement - by Guest - 05-06-2009, 04:36 PM

Re: philco 48-1283 wiring issue - by Bob - 05-06-2009, 08:41 PM

Re: philco 48-1283 wiring issue - by planigan - 05-08-2009, 01:13 AM

View a Printable Version

Users browsing this thread:

Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Since you stated earlier, you have a console 38-7XX. They also had a 38-7T (table), and 38-7CS (chairside). A very nic...GarySP — 01:18 PM
Part numbers to model cross
That I wouldn't know, but sometimes the radio document itself shows one, same as the capacitor cans' etc pinouts.morzh — 12:46 PM
Part numbers to model cross
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me