Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Picked up a new Philco
#1

Hi;
I picked up a new-old Philco on the weekend at of all things an old car swap meet. It's a Philco model 40-81, code 122, a cloth covered portable with four tubes. It isn't in bad shape, just dirty, the back is missing but everything else is still there. I suspect the battery pack must have leaked and ruined the back as the chassis has some rust spots. What's interesting is that the set has a built in loop antenna, but it wasn't mounted on the back it was would around the outside of the cabinet under the cloth cover. It also has a rather large speaker, five or more inches. Apparently the B+ was only 67-1/2 volts, I didn't know that portables from then were made to run on such things in 1940. I will clean it up and see if I can get it going, there are only five condensers in the whole radio (aside from micas) so not much to go wrong other then the rubber wire. Here's a picture of a similar set for reference, I don't have one of mine yet:
http://www.philcoradio.com/gallery/1940a.htm
Best Regards
Arran


Messages In This Thread
Picked up a new Philco - by Arran - 05-06-2009, 09:04 PM
Re: Picked up a new Philco - by Sean - 05-08-2009, 09:25 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently 510 online users. [Complete List]
» 2 Member(s) | 508 Guest(s)
AvatarAvatar

>