03-10-2016, 02:52 PM
Getting geared up to do the AM alignment on the 48-1256 I've been slowly trying to restore. Never done one of these on my own before, so I've got a few questions.
For reference, here's a pic of the alignment instructions from Sam's:
[Image: http://i.imgur.com/Y42Czls.jpg]
1. I have an isolation transformer. Am I reading that correctly that if I use it, I won't need to solder in the .01uf or 200pf caps?
2. What does it mean in the coupling section about high side & low side? And where do I access B-?
3. Any idea what that smudged section under Output Meter might have said?
For reference, here's a pic of the alignment instructions from Sam's:
[Image: http://i.imgur.com/Y42Czls.jpg]
1. I have an isolation transformer. Am I reading that correctly that if I use it, I won't need to solder in the .01uf or 200pf caps?
2. What does it mean in the coupling section about high side & low side? And where do I access B-?
3. Any idea what that smudged section under Output Meter might have said?
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
