[CR220]

I did a check of the resistors in the power unit, and found the all to be high-better than 10%. I did find a part that does not show up on the parts diagram. It is a tapped resistor with a Philco part number of 33-3311. The literature says it should have a number of 33-3302. I believe that the original was there at one time, and was replaced with the one that is there now. The one that is there now only has 3 taps. The one that is supposed to be there had 5. If this part does the job of the old one, that would be fine. I would just like to know what the values of the current part are.