Posts: 7,301
Threads: 269
Joined: Dec 2009
City: Roslyn Pa
If you have an AC ma meter you may want check the mains current. 1amp seems rather large,
heater current for the 117Z6 is only 75ma+what ever else radio requires. Or check the wattage rating of the set and figure about 1 amp=100w. Your set is probably around 20-30w= less than a 1/2 amp.
Terry
(This post was last modified: 06-20-2016, 08:01 AM by Radioroslyn.)
Messages In This Thread
RE: A Zenith 8G005YT restore - by Radioroslyn - 06-20-2016, 07:58 AM
Users browsing this thread:
|
Recent Posts
|
Philco 42-345 Restoration/Repair
|
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM |
Philco 42-345 Restoration/Repair
|
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM |
Philco model 38 code 121 not receiving signal.
|
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM |
Testing a speaker and output transformer Trutone A2-G
|
The equivalent of one short turn is basically the same as that of a shorted load.
If it is the primary's turn, then the ...morzh — 03:53 PM |
Testing a speaker and output transformer Trutone A2-G
|
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM |
Philco model 38 code 121 not receiving signal.
|
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM |
Philco model 38 code 121 not receiving signal.
|
Well why not! :lol:Stormlord5500 — 03:14 PM |
Philco model 38 code 121 not receiving signal.
|
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM |
Testing a speaker and output transformer Trutone A2-G
|
morzh
Short-circuited turns can be considered as a half-dead transformer.
But on this case transformer will hot and s...Vlad95 — 11:01 AM |
Testing a speaker and output transformer Trutone A2-G
|
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM |
Who's Online
|
There are currently 2274 online users. [Complete List] » 1 Member(s) | 2273 Guest(s)
|
|
|

|