Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Scarce Console ?
#8

Since the seller was located 45 mi n of Nashville, perhaps this was a special "one-off" Philco (aka) "Grand ol Opry" model set? Reckon? Icon_wink
Someone did a good job making & matching-up the front-panel to fit properly.
Lordy mercy, for that price, seems the seller could have included a "hank" of 20' single-strand insulated antenna wire? Icon_rolleyes
Bet the spkr used had lots of bass tone? I figure the "extended-bass" response would equal a good-rumble, such as "pull my finger" type sounds? ( just kidding again!)Icon_wink


Messages In This Thread
Scarce Console ? - by Drew - 07-25-2009, 06:25 PM
Re: Scarce Console ? - by Ron Ramirez - 07-25-2009, 10:36 PM
Re: Scarce Console ? - by Drew - 07-26-2009, 12:27 PM
Re: Scarce Console ? - by exray - 07-26-2009, 03:28 PM
Re: Scarce Console ? - by Doug Houston - 07-28-2009, 05:10 PM
Re: Scarce Console ? - by Arran - 07-28-2009, 07:12 PM
Re: Scarce Console ? - by jayoungs - 07-29-2009, 10:49 AM
Re: Scarce Console ? - by Texasrocker - 08-01-2009, 02:27 AM



Users browsing this thread:
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM
Model 70 Cabinet Trim
Hello musar, First all welcome to the forum and yes that is true that steve stopped making trim . Sincerely Richar...radiorich — 12:13 AM
Model 70 Cabinet Trim
I have recently come into possession of a Model 70.  The trim around the base needs to be replaced.  If this were years ...musar — 12:07 AM
philcorepairbench.com - shadow-meter
Anyone know of a way to recover these files from the repair bench? Thanks. fenbach — 11:16 PM
Philco model 38 code 121 not receiving signal.
That's true. Of course If I were to get a vtvm I'd probably have to sink money in to it to get it working right. Probabl...Stormlord5500 — 08:44 PM
Philco model 38 code 121 not receiving signal.
A DMM is good enough. One rarely has to measure indictance, but if you do, short of getting a serious LCR meter (I hav...morzh — 07:35 PM
Testing a speaker and output transformer Trutone A2-G
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now. Have better volu...murf — 03:43 PM
Philco model 38 code 121 not receiving signal.
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM

[-]
Who's Online
There are currently no members online.

>