[Mike L]

Thanks for all the info and suggestions. Hopefully this weekend I can get back to it and check a few thing out. I did notice a few "cold" solder joints from prior to me repairs, so I'll address those issues as well. Still trying to decipher the schematic out as my part locations are not quite the same. I know there were several different chassis runs. Some of the part reference numbers are not very clear. I do have one resistor that I cannot explain its location vs. the schematic. I know I have seen it on others photos of their chassis so It is most likely a run change. It is a 1meg. and runs from center terminal of cap block #10 to the 4mF electrolytic.