Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco model 77
#3

 The speaker is correct, my model 96 has one as well, the standard console speaker in use in the 1929-31 models was the Model H speaker. As for why it does not play these sets pretty well need all the capacitors replaced, many of the resistors too. One think to check for is if the audio output transformer is open, each leg of the primary should be connected to the plate pins of the #45 tubes. It could also be an open audio interstage transformer, though that often results in low volume and not a dead radio. Have you tried connecting the antenna lead to the grid caps of each of the #24 tubes? Sometimes one or more of the RF coils can go open, so if one coil is bad between the antenna and the following stage the radio might not pick up anything. Fortunately the RF coils are single layered so they should be easy to repair if they are open.
Regards
Arran


Messages In This Thread
Philco model 77 - by flatheadjr - 09-14-2016, 10:24 PM
RE: Philco model 77 - by flatheadjr - 09-14-2016, 10:25 PM
RE: Philco model 77 - by Arran - 09-16-2016, 03:17 AM
RE: Philco model 77 - by flatheadjr - 09-16-2016, 09:52 PM
RE: Philco model 77 - by Arran - 09-17-2016, 03:50 AM
RE: Philco model 77 - by flatheadjr - 09-17-2016, 08:25 PM
RE: Philco model 77 - by Radioroslyn - 09-17-2016, 09:21 PM
RE: Philco model 77 - by flatheadjr - 09-17-2016, 09:38 PM
RE: Philco model 77 - by Radioroslyn - 09-18-2016, 12:08 AM
RE: Philco model 77 - by flatheadjr - 09-18-2016, 12:47 AM
RE: Philco model 77 - by Radioroslyn - 09-18-2016, 02:52 PM
RE: Philco model 77 - by flatheadjr - 09-18-2016, 04:12 PM
RE: Philco model 77 - by Radioroslyn - 09-18-2016, 04:46 PM
RE: Philco model 77 - by flatheadjr - 09-18-2016, 06:11 PM
RE: Philco model 77 - by Radioroslyn - 09-18-2016, 07:37 PM
RE: Philco model 77 - by flatheadjr - 09-18-2016, 08:56 PM
RE: Philco model 77 - by Radioroslyn - 09-18-2016, 11:56 PM
RE: Philco model 77 - by flatheadjr - 09-19-2016, 12:20 PM
RE: Philco model 77 - by Radioroslyn - 09-19-2016, 01:09 PM
RE: Philco model 77 - by klondike98 - 09-19-2016, 03:01 PM
RE: Philco model 77 - by flatheadjr - 09-20-2016, 09:52 AM
RE: Philco model 77 - by flatheadjr - 09-20-2016, 11:25 PM
RE: Philco model 77 - by flatheadjr - 01-11-2017, 09:14 PM
RE: Philco model 77 - by Ron Ramirez - 01-11-2017, 09:55 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 70 Cabinet Trim
musar , Well if you have any more questions feel free to post away . Sincerely Richardradiorich — 08:56 PM
Model 70 Cabinet Trim
Although I have not made any cabinets or cabinet parts for a couple of years, I still have some parts left over, includi...Steve Davis — 06:26 PM
philcorepairbench.com - shadow-meter
Thanks Ron.fenbach — 02:43 PM
Model 70 Cabinet Trim
Thank you, Gary. Before making my original post, I had clicked on "Steve Davis Cabinets" only to find that it...musar — 02:25 PM
philco predicta
Welcome to the Phorum, cgl18! I am not your resource for television repair, but lots of friendly help is available here...GarySP — 02:12 PM
Model 70 Cabinet Trim
Welcome to the Phorum, musar! You can send Steve Davis a private message (PM). The site is at the top of the Home page...GarySP — 02:09 PM
Model 70 Cabinet Trim
How do I contact him? The only contact information for him I could find when searching online was a telephone number th...musar — 10:38 AM
philco predicta
Hello, good afternoon, I would like to ask what the possible problem could be if I don't have an image on the screen. I ...cgl18 — 10:19 AM
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM

[-]
Who's Online
There are currently 1501 online users. [Complete List]
» 1 Member(s) | 1500 Guest(s)
Avatar

>