[vecher]

All, I just acquired this tester.

[Image: http://i292.photobucket.com/albums/mm38/...adi13e.jpg]


It was working as advertised. However I noticed that most if not all the tubes I tested were measuring the same. So I took it out of cabinet . Noticed some repairs were done , new caps a couple of new resistors. ETC.. I decided to measure the filament voltage to see if it was correct.. The manual says to use the line adjust to set the meter at the Line adjust position. When I did that the voltage was low. I was using the 5 volt position. It measured around 4.7 volts. When I put in a 5Y3 tube it could barely be set back to the Line adjust position. It measured around 4.6 volts.. could not get it any higher..

Here is schematic..

[Image: http://i292.photobucket.com/albums/mm38/...b9dhwt.jpg]


More to follow..

Skip...