[Radioroslyn]

Ok, Hooked up my Variac to input of transformer.. Measured YEL-YEL on the 5Y3gt tube ( tube was not in place)

At 30 volts in Output was  190 VAC
   50 volts in Output was  304 VAC
   60 volts in Output was  370 VAC
  115 volts in Output was  710 VAC   Current draw was 250MA

This is NO LOAD .. Using a Fluke 77 multimeter..

Transformer cool to touch.. Is this in ballpark?

Skip...

Hey Skip,
I'm a bit of a daredevil when I check out a pt. I look for leaking wax, burnt smell, and physical damage to paper and winding. If I don't find any of these signs I pull the rectifier and let her rip. Check AC voltage from plate to plate of the rectifier. If voltage seems ok then I let it run for a bit and check for heating. If cool then all so kewl. Tipically what fails is the HV winding sometimes the primary. THe filament winding are pretty tough except on Valiant for the 866's.