Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

Philco model 87
#23

Not quite sure what your question is but it's a 10K pot. To check it you'll need to disconnect the wire on center terminal as the coil it's connected to has a much low resistance and will effect your reading. No voltage on it.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!

Terry


Messages In This Thread
Philco model 87 - by flatheadjr - 09-28-2016, 09:27 PM
RE: Philco model 87 - by flatheadjr - 01-11-2017, 09:24 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 04:40 PM
RE: Philco model 87 - by Radioroslyn - 01-21-2017, 07:44 PM
RE: Philco model 87 - by Mondial - 01-21-2017, 09:34 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 09:52 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 12:07 AM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 12:30 AM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 07:10 AM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 02:16 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 03:11 PM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 03:48 PM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:25 AM
RE: Philco model 87 - by flatheadjr - 01-23-2017, 01:37 AM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:11 PM
RE: Philco model 77 - by Radioroslyn - 09-29-2016, 10:29 AM
RE: Philco model 77 - by flatheadjr - 09-29-2016, 12:17 PM
RE: Philco model 77 - by Arran - 10-01-2016, 05:00 AM
RE: Philco model 77 - by flatheadjr - 10-08-2016, 06:22 PM
RE: Philco model 77 - by Radioroslyn - 10-08-2016, 08:05 PM
RE: Philco model 77 - by flatheadjr - 10-12-2016, 09:31 PM
RE: Philco model 77 - by Radioroslyn - 10-12-2016, 10:35 PM
RE: Philco model 77 - by Radioroslyn - 10-17-2016, 08:05 PM
RE: Philco model 77 - by flatheadjr - 01-04-2017, 11:08 PM
RE: Philco model 77 - by Radioroslyn - 01-05-2017, 10:30 AM
RE: Philco model 77 - by flatheadjr - 01-05-2017, 09:46 PM
RE: Philco model 77 - by Arran - 01-09-2017, 04:02 AM
RE: Philco model 77 - by Radioroslyn - 01-09-2017, 11:42 AM
RE: Philco model 77 - by flatheadjr - 01-11-2017, 12:03 AM
RE: Philco model 77 - by Ron Ramirez - 01-11-2017, 01:20 PM
RE: Philco model 77 - by Radioroslyn - 01-11-2017, 09:03 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco P45-6365 Universal Transformer Instruction Manual
Can anyone guide me to where this may be found?GRG — 03:00 PM
54C Complete Teardown/Rebuild
I don't think that I have encountered a 12Z3 before, curious how it uses one of those but includes a #43, which is a 25 ...Arran — 02:17 PM
HiFi (Chifi) tube amp build - but my own design.
It's the other forum. I'm also in DIY, but mostly read there. Honestly, I kinda jumped into this without much thought to...TV MAN — 10:43 AM
Philco 71 Code 125
Hello,  I am in need of a schematic for this radio. Mine has the three separate circular tube shields and a shadow me...dconant — 08:06 AM
Stromberg Carlson 1500 Squeal
And life just keeps getting more complicated.dconant — 07:57 AM
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM

[-]
Who's Online
There are currently 2684 online users. [Complete List]
» 1 Member(s) | 2683 Guest(s)
Avatar

>