[jcassity]

now on to my difficult questions.

see picture
Q- to the left is code 122 prints and at no point is the on off switch tied to my rectifer tube.
In the real world, i have what is hand sketched to the right.
I did some reading and saw people talking about how to bypass the primary of the power xfrmr when it craps out.
Does it appear this mod was done here?

Q- The code 122 prints indicate i should have a dozen conductors on my transformer Pri&Sec  combined.  I only have 10 conductors total.
There is one single conductor that is spared back with tape on it and its been like that prior to me touching.

The radio has played in this config until i decided to rework it.

IT did hummmm upon initial power up so i am taking care of filter caps and such.

This is an important next step for me so i will move on to cap and resistor replacement while someone notices and maybe replies.

Q- Is there any way for me to identify other than resistance values what conductors on my xfrmr are?
The prints indicate a color code the secondary's but all i can see is a bunch of brownish cloth covered wires.
I can "almost" see a hint of color in a couple but feel like its my brain eye coordination wanting to see it.

pay no attentiion to the "speaker field", i dont have that on code 125 updates.