46-1226 code 125 restoratioin *DONE
Posts: 640
Threads: 48
Joined: Mar 2017
City: Gap Mills Wv 24941
here is how i finally solved the mounting of the filter C102.
i fab'd up some mounting ears so now the bakalite plate is the point the mounts press down on to keep the canister rigid.
since i cut slots all the way around, i just broke off two of opposite sides and drilled the chassis then added the clips.
this should be fine.
Attached Files
Image(s)
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by jcassity - 04-16-2017, 09:55 PM
Users browsing this thread: 2 Guest(s)
Recent Posts
Another amp build - here I go again!
Sweet!
I actually have a Dyba Mark 4 that I had been running with 6L6s with no mods. seemed to my 14-year-old head a...MrFixr55 — 12:57 AM
PT-6 finished!!
Hi Gang,
Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM
Electrolytic restuffing/internals
Look here:
Philco-F676-124
Vlad95 — 08:02 PM
PT-6 finished!!
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM
Electrolytic restuffing/internals
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM
Another amp build - here I go again!
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM
Electrolytic restuffing/internals
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM
philco predicta
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM
HiFi (Chifi) tube amp build - but my own design.
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM
philco predicta
Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM
Who's Online
There are currently no members online.