04-19-2017, 12:34 AM
Since I've worked on several Philcos from around this year, I have pretty good documentation and references for parts values. 
However, the 2-part electrolytic (part 101 on the list, part #30-2045) indicates an 8ufd and 10ufd cap, with 1 at 450v, and the other at 50v. So which is the lower voltage rating? And is it OK to just put a 450v in place 
The original cans have been replaced above the chassis, and some are installed under the chassis as you can hopefully see in the underside chassis pic above.
I'm anxious to work on this,
so I'm studying up, and wanting to start rounding up parts for it.
If anyone has this info, or any other advice, it would be most welcome.
However, the 2-part electrolytic (part 101 on the list, part #30-2045) indicates an 8ufd and 10ufd cap, with 1 at 450v, and the other at 50v. So which is the lower voltage rating? And is it OK to just put a 450v in place The original cans have been replaced above the chassis, and some are installed under the chassis as you can hopefully see in the underside chassis pic above. I'm anxious to work on this,
so I'm studying up, and wanting to start rounding up parts for it.If anyone has this info, or any other advice, it would be most welcome.
Blessings,
Jeff W.
Jonesboro, Arkansas
http://jeffsradios.weebly.com
God loves you as you are, not as you should be, because none of us are as we should be. - Brennan Manning
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
