46-1226 code 125 restoratioin *DONE
Posts: 182
Threads: 5
Joined: Feb 2017
City: Cedar Rapids Iowa
My reply is working as expected now. I wonder if it's because the last time I posted I did a "Quick Reply" and it cleared out a cache or something. Prior to that it didn't matter if I did a "New Reply" or a "Reply", it always included Radioroslyn's post. Oh well, seems to be cleared up now.
In the picture I posted earlier I said I had 2 on the underside of my tuner chassis. It turns out I have 3...there is a third one stacked under the one on the left in the photo I posted. Your's looks similar to the one on the right in my photo. I'll take a close look at it when I go downstairs to work on it later today and see if I can find a wire like that.
Rich
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by criageek - 04-19-2017, 08:54 AM
Users browsing this thread: 3 Guest(s)
|
Recent Posts
|
Another amp build - here I go again!
|
Sweet!
I actually have a Dyba Mark 4 that I had been running with 6L6s with no mods. seemed to my 14-year-old head a...MrFixr55 — 12:57 AM |
PT-6 finished!!
|
Hi Gang,
Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM |
Electrolytic restuffing/internals
|
Look here:
Philco-F676-124
Vlad95 — 08:02 PM |
PT-6 finished!!
|
Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM |
Electrolytic restuffing/internals
|
Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM |
Another amp build - here I go again!
|
Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM |
Electrolytic restuffing/internals
|
There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM |
philco predicta
|
If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM |
HiFi (Chifi) tube amp build - but my own design.
|
Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM |
philco predicta
|
Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM |
Who's Online
|
There are currently no members online. |
|

|