1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 41-608 connector question.
Sean
Member
***
Posts: 150
Threads: 4
Joined: Oct 2005
City: Sullivan, MO
#14

01-11-2010, 11:07 PM
Harlan,

Here are the 1941 models with the BOL pickup that I come up with from the service book: 41-608, 41-609, 41-610, 41-611, 41-616, 41-620, 41-623, 41-624, 41-625, 41-629. The 41-608 through 41-611 use the 32-8135 transformer.

I looked at the Rider's on Nostalgia Air and you are right, they do not have the parts list. I have the service info for the radio, changer, and home recording unit scanned as PDFs. Send me an email and I can send them to you. seanbart at fidnet dot com.

You should also check out Chuck Schwark's page about the pickup. According to the chart on that page, the photo cell puts out about 42mV with 3V on the lamp so it is a pretty low level signal.
Sean
WØKPX
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 41-608 connector question. - by Harlan - 01-06-2010, 10:27 PM
Re: Philco 41-608 connector question. - by Sean - 01-06-2010, 10:43 PM
Re: Philco 41-608 connector question. - by Harlan - 01-06-2010, 11:44 PM
Re: Philco 41-608 connector question. - by Sean - 01-07-2010, 10:14 AM
Re: Philco 41-608 connector question. - by Harlan - 01-07-2010, 11:14 AM
Re: Philco 41-608 connector question. - by Sean - 01-07-2010, 01:00 PM
Re: Philco 41-608 connector question. - by Harlan - 01-07-2010, 07:24 PM
Re: Philco 41-608 connector question. - by Sean - 01-08-2010, 12:19 PM
Re: Philco 41-608 connector question. - by Sean - 01-09-2010, 12:41 AM
Re: Philco 41-608 connector question. - by Harlan - 01-09-2010, 01:03 AM
Re: Philco 41-608 connector question. - by Harlan - 01-10-2010, 07:25 PM
Re: Philco 41-608 connector question. - by Sean - 01-11-2010, 11:07 PM
Re: Philco 41-608 connector question. - by Harlan - 03-29-2010, 10:31 PM
Re: Philco 41-608 connector question. - by Sean - 03-30-2010, 09:19 AM
Re: Philco 41-608 connector question. - by Harlan - 03-30-2010, 10:14 AM
Re: Philco 41-608 connector question. - by Harlan - 03-30-2010, 09:38 PM
Re: Philco 41-608 connector question. - by Sean - 03-31-2010, 08:36 AM
Re: Philco 41-608 connector question. - by Harlan - 03-31-2010, 03:34 PM
Re: Philco 41-608 connector question. - by Sean - 04-01-2010, 09:37 AM
Re: Philco 41-608 connector question. - by Harlan - 04-01-2010, 10:01 AM
Re: Philco 41-608 connector question. - by Guest - 06-12-2010, 01:32 PM
Re: Philco 41-608 connector question. - by Harlan - 10-15-2010, 10:02 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM
Philco model 38 code 121 not receiving signal.
Good news everyone! I think I have found everything I need for rewinding the antenna coil primary. I found some pla...Stormlord5500 — 09:40 AM
Philco Battery-WWII vintage
My younger sister went to SUNY Plattsburg NY, (BS, MS, RN) in the late 1970sabout 10 min from the Northern NY / Canada b...MrFixr55 — 07:59 AM

[-]
Who's Online
There are currently 1778 online users. [Complete List]
» 3 Member(s) | 1775 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration