[criageek]

I'm both encouraged and a bit stumped now.  I figured out that my signal generator was not producing a modulated signal and fixed that.  There is a trimpot inside that needed a little adjustment in order for the internal oscillator to start.  Once I found that I adjusted it for the best looking sine wave and now I get a nice modulated signal.  So I went through the AM tests in the documentation Chuck sent me and all succeeded. Including injecting a 1000kHz modulated signal into the antenna terminal and tuning to it for a nice tone through the speaker.  I would think that means everything is working correctly, but I still get no stations.  I even dug out the loop antenna from the cabinet and attached that, but still nothing.  Any suggestions for how to proceed?

Thanks,
Rich