04-27-2017, 02:01 PM
Mondial
Thanks, that's just the info I needed.
I just went back and re-read the AK info and you are exactly correct.
So...why was I getting only 190-230 mV on two of the output tube cathode resistors, when the readings are all about the same when measured from cathode to ground? Or from each respective point (A, B, C, D) to ground?
Thanks, that's just the info I needed.
I just went back and re-read the AK info and you are exactly correct.
So...why was I getting only 190-230 mV on two of the output tube cathode resistors, when the readings are all about the same when measured from cathode to ground? Or from each respective point (A, B, C, D) to ground?
--
Ron Ramirez
Ferdinand IN