46-1226 code 125 restoratioin *DONE
Posts: 640
Threads: 48
Joined: Mar 2017
City: Gap Mills Wv 24941
updated voltage results above....
on the candohm R100, i was also at least expecting something like -15v per the diagram- 46-1226 code 125 power supply update to the far right.
T100 center tap of the hv secondary (green) to>
terminal strip to>
white wire to>
C101 filter cap group (parallel caps with negatives tied to>
one side of R100 candohm to>
chassis.
if you look at the prints... Filter cap C102 negative can bond to chassis direclty.
Filter cap C101 can not be bonded directly to chassis, it must go through R100 before getting to chassis.
(This post was last modified: 05-02-2017, 09:07 AM by jcassity.)
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by jcassity - 05-02-2017, 09:05 AM
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Another amp build - here I go again!
|
| Sweet!
I actually have a Dynaco Mark 4 that I had been running with 6L6s with no mods. Seemed to my 14-year-old head a...MrFixr55 — 12:57 AM |
|
PT-6 finished!!
|
| Hi Gang,
Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM |
|
Electrolytic restuffing/internals
|
| Look here:
Philco-F676-124
Vlad95 — 08:02 PM |
|
PT-6 finished!!
|
| Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM |
|
Electrolytic restuffing/internals
|
| Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM |
|
Another amp build - here I go again!
|
| Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM |
|
Electrolytic restuffing/internals
|
| There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM |
|
philco predicta
|
| If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM |
|
HiFi (Chifi) tube amp build - but my own design.
|
| Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM |
|
philco predicta
|
| Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM |
|
Who's Online
|
There are currently 251 online users. [Complete List]
» 4 Member(s) | 247 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
