46-1226 code 125 restoratioin *DONE
Posts: 1,114
Threads: 14
Joined: Feb 2013
City: Irvington, NY
Yes, that is correct. The center tap and C101 negative should only connect to chassis through R100.
Thats why I said to measure the resistance from the center tap to ground. You should read 271 ohms, the resistance of R100.
If you do not read 271 ohms there is a problem. There must be 15 to 20 volts at the center tap to provide bias for the output tubes. This voltage is developed across R100 so if you have no voltage across R100, then the center tap is somehow bypassing R100 with some other path to ground.
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by Mondial - 05-02-2017, 09:27 AM
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Another amp build - here I go again!
|
| Sweet!
I actually have a Dynaco Mark 4 that I had been running with 6L6s with no mods. Seemed to my 14-year-old head a...MrFixr55 — 12:57 AM |
|
PT-6 finished!!
|
| Hi Gang,
Tube heaters are not "Ohmic" devices (that maintain specified resistance over wide temperature, c...MrFixr55 — 12:03 AM |
|
Electrolytic restuffing/internals
|
| Look here:
Philco-F676-124
Vlad95 — 08:02 PM |
|
PT-6 finished!!
|
| Well the 35Z3 doesn't have a tap on the tube heater for a pilot light, so in this set they have the dial lamp paralleled...Arran — 06:21 PM |
|
Electrolytic restuffing/internals
|
| Thanks. I think I try to cut this as suggested. I don’t have a lathe, but I do have a tap and die set. I am going to see...bridkarl — 04:46 PM |
|
Another amp build - here I go again!
|
| Hey all! Well, I guess that with what I learned from my last build, it's time to move up the ladder another rung and tak...TV MAN — 04:38 PM |
|
Electrolytic restuffing/internals
|
| There are various ways to handle this, one is to cut near just above that rolled in area is near the bottom, using the r...Arran — 04:36 PM |
|
philco predicta
|
| If you have a television signal generator (a must-have for TV repair) and an oscilloscope (the same), then this problem ...RadioSvit — 04:23 PM |
|
HiFi (Chifi) tube amp build - but my own design.
|
| Thanks Rod for the offer but I don't think those would work. There's some differences in the sizing and mounting holes b...TV MAN — 03:13 PM |
|
philco predicta
|
| Bob Anderson (Bandersontv) on Youtube would be the go-to guy on these. Lots of good videos. I don't know what model you ...TV MAN — 03:02 PM |
|
Who's Online
|
There are currently 253 online users. [Complete List]
» 2 Member(s) | 251 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
