1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Vintage Hi-Fi, Stereo and Audio

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
The Fisher 400 Receiver
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#16

07-03-2017, 11:02 AM
But the "A" is important on the 7189A. Check the plate voltage rating. I would not stick a 6BQ5 in a circuit built for 7189As. I have used the Russian tube though, in my brothers Fisher. As far as I know, they have not melted - yet.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Website Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
The Fisher 400 Receiver - by Ron Ramirez - 06-03-2017, 08:51 PM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-03-2017, 08:57 PM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-03-2017, 08:59 PM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-03-2017, 09:04 PM
RE: The Fisher 400 Receiver - by Arran - 06-23-2017, 03:21 AM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-23-2017, 10:34 AM
RE: The Fisher 400 Receiver - by Phlogiston - 06-23-2017, 01:31 PM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-23-2017, 05:43 PM
RE: The Fisher 400 Receiver - by Ron Ramirez - 06-23-2017, 05:55 PM
RE: The Fisher 400 Receiver - by Arran - 06-29-2017, 06:43 PM
RE: The Fisher 400 Receiver - by Phlogiston - 06-29-2017, 09:07 PM
RE: The Fisher 400 Receiver - by Arran - 07-02-2017, 02:34 AM
RE: The Fisher 400 Receiver - by Phlogiston - 07-02-2017, 10:03 AM
RE: The Fisher 400 Receiver - by Arran - 07-03-2017, 04:38 AM
RE: The Fisher 400 Receiver - by Ron Ramirez - 07-03-2017, 07:32 AM
RE: The Fisher 400 Receiver - by Phlogiston - 07-03-2017, 11:02 AM
RE: The Fisher 400 Receiver - by Paul Philco322 - 07-16-2017, 11:05 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2111 online users. [Complete List]
» 4 Member(s) | 2107 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Vintage Hi-Fi, Stereo and Audio