Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Please ID this Silvertone
#16

If you are concerned abt the diode you could parallel  another w/it or use a 1N5408 (1000v 3A). Disconnect the 240 ohm cord and replace with the X connections.


Attached Files Image(s)
   

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Please ID this Silvertone - by vecher - 05-22-2017, 11:42 PM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 12:11 AM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 01:11 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 07:39 AM
RE: Please ID this Silvertone - by Eliot Ness - 05-23-2017, 08:37 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 09:13 AM
RE: Please ID this Silvertone - by sam - 05-23-2017, 11:19 AM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 04:09 PM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 05:00 PM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 08:38 PM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 12:09 AM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 08:32 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-05-2017, 06:18 PM
RE: Please ID this Silvertone - by vecher - 07-05-2017, 11:28 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-06-2017, 12:30 AM
RE: Please ID this Silvertone - by vecher - 07-07-2017, 12:08 AM
RE: Please ID this Silvertone - by vecher - 09-22-2017, 11:17 PM



Users browsing this thread:
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Since you stated earlier, you have a console 38-7XX.  They also had a 38-7T (table), and 38-7CS (chairside).  A very nic...GarySP — 01:18 PM
Part numbers to model cross
That I wouldn't know, but sometimes the radio document itself shows one, same as the capacitor cans' etc pinouts.morzh — 12:46 PM
Part numbers to model cross
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM

[-]
Who's Online
There are currently 1216 online users. [Complete List]
» 1 Member(s) | 1215 Guest(s)
Avatar

>