07-19-2017, 09:31 AM
Ok it's looking much better but we need to find what happened to the -20vdc on pin 5. Lets take a look at the junction of 134 and 135, between there and chassis ground should see the -20v or so. If not go to 140 (the backwards one) do you have -20v across it? Testing can be done with the 6L6's out. If you do have the -20v around it would seem that your interstage transformer isn't wired it properly and we can go over that too. The 6L6 that had the high + voltage on pin 5 would appear to be a goner. OBTW Why don't you replace that backwards cap, if it had a high + voltage across it it's going to be shorted. Just a thought.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
