Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-4 wire identification??
#6

OBTW Here's a little something to listen to whilst your working:  https://archive.org/details/TalesOfTheTexasRangers

A little service tip, don't power it up with out the spkr plugged in. It will blow the pants off of #66 which in turn will takeout the 5Y4 and maybe if your unlucky #68 read $$$$. Without #65 (the field coil part of the spkr) in the circuit there is no load presented to #66 and it will keep charging up till it surpasses it's maximum voltage rating (450v when new) and then shorts. Only bad things happen after that.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 38-4 wire identification?? - by CodyTerry - 10-15-2017, 09:13 PM
RE: Philco 38-4 wire identification?? - by Radioroslyn - 10-16-2017, 07:51 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The list of my radio & TV collection!
Sorry, these are my old videos, so there are no English subtitles yet. RadioSvit — 06:00 AM
The list of my radio & TV collection!
Yes, MrFixr55. I agree with you, this Galicrafters is structurally very similar to the Zenith Transoceanic H500, as well...RadioSvit — 05:58 AM
The list of my radio & TV collection!
Hi Richard. I really like the Hickok, it is very convenient to use. I have another tube tester - the Soviet L1-3. It is ...RadioSvit — 05:27 AM
The list of my radio & TV collection!
Arran. I completely agree with you. I also noticed that the Canadian consoles General Electric, RCA and De Forest Crosle...RadioSvit — 05:11 AM
Electrolytic restuffing/internals
I don’t have a vise so I had to hold it in my hand. Not optimal but covered up by the hvac tape in the end. I have a few...bridkarl — 11:52 PM
Electrolytic restuffing/internals
Bridkarl A question. For a hacksaw the cut looks a little...jagged. Why?morzh — 11:45 PM
The list of my radio & TV collection!
As usual, an interesting post from you, Peter. This seems to be similar to the RCA 3-BX-671 and the Zenith Transoceanic...MrFixr55 — 11:41 PM
The list of my radio & TV collection!
Hello Peter, Thank you for sharing your new video and looks like your weather is nice their too. it was like 25 Cel...radiorich — 11:05 PM
Electrolytic restuffing/internals
hello bridkarl, I will post some better photos ! Sincerely Richardradiorich — 10:14 PM
Electrolytic restuffing/internals
I just taped the two pieces of the cap together, but I can see your method is better. I just held the lead in with solde...bridkarl — 08:18 PM

[-]
Who's Online
There are currently no members online.

>