[Hot Rod]

Glad you solved the wire mystery.  I remember that Philco has an adjustment procedure for the MT.  Mine works.  It makes the station come in worse, but at least is does something   .   I already replaced the 0.7uF and two 0.1uF.

My suspicious 0.1uF cap goes from the center terminal of the treble control then directly to ground, no resistor.  I didn't disconnect it.  I know everything is affected by everything else in the circuit, but didn't think it would in this case.  I will check it disconnected before I condemn it.

I emailed Mark Oppat about a replacement treble control and a new dial but no response as yet.  I hope everything is ok. 

I picked up a 1935 Emerson tombstone model 36 last night.  SOMEBODY STOP ME BEFORE I BUY AGAIN!!!