RCA 110K2 Unexpected project
Posts: 1,385
Threads: 45
Joined: Nov 2017
City: Menlo Park
State, Province, Country: CA
OK, enough blathering on. Pictures are more fun anyway. Here is the chassis as it sat on the bench this morning - almost all cleaned up, with just a few areas to tackle, and the decision whether or not to pull the tuning condenser for a proper clean.
I don't hold with furniture that talks.
Messages In This Thread
RE: RCA 110K2 Unexpected project - by EdHolland - 04-09-2018, 04:13 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Testing a speaker and output transformer Trutone A2-G
|
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now.
Have better volu...murf — 03:43 PM |
Philco model 38 code 121 not receiving signal.
|
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM |
Philco model 38 code 121 not receiving signal.
|
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM |
Philco model 38 code 121 not receiving signal.
|
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM |
Philco model 38 code 121 not receiving signal.
|
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM |
Philco model 38 code 121 not receiving signal.
|
I've reinstalled the coil. Now IT'S ALIVE!!!!!!
I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM |
Philco model 38 code 121 not receiving signal.
|
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM |
PT 6 chassis screws size???
|
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM |
Philco model 38 code 121 not receiving signal.
|
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM |
Philco model 38 code 121 not receiving signal.
|
Thankyou for the kind words sir.
I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM |
Who's Online
|
There are currently 2778 online users. [Complete List] » 2 Member(s) | 2776 Guest(s)
|
|
|

|