Posts: 481
Threads: 18
Joined: Jan 2013
City: Mesa, AZ
Well, here still she sits in front of the 38-1. The speaker vibrates as if though it were plugged in (it's not) whenever I crank up the Philco. She still has all of the dust in the backside of it in the exact same position as when I picked it up. It has been a challenge to keep my grubby little fingers off it, and will continue to be, I much fear. I've done NOTHING to it so far. Had to bring my brother back to the hospital again yesterday, 2nd time in 4 days, and he will be there for a couple more, so I still haven't got a good handle of what kind of radio he's into. I know what I like, but that is besides the point. This radio has a wonderful aura and I feel that it has lived a very full and rich life until it was put into dry but crowded storage, causing the damage to the speaker et al. (Although myself, I think some stupid kid poked their finger into the speaker cloth and cone). Looking for info on this, I did stumble across an old sales listing for a 10T- 5 years ago- that sold (on the radio attic, I think) for $950!!! The cabinet was restored beautifully, but there was zero doubt that the set had seen water in the past, as the lower left rear bottom of the cabinet was clearly disintegrated to a goodly degree, and the chassis had a lot of rust on it AFTER restoration. I guess this model IS quite desirable after all!!!
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Model 70 Cabinet Trim
|
musar ,
Well if you have any more questions feel free to post away .
Sincerely Richardradiorich — 08:56 PM |
Model 70 Cabinet Trim
|
Although I have not made any cabinets or cabinet parts for a couple of years, I still have some parts left over, includi...Steve Davis — 06:26 PM |
philcorepairbench.com - shadow-meter
|
Thanks Ron.fenbach — 02:43 PM |
Model 70 Cabinet Trim
|
Thank you, Gary. Before making my original post, I had clicked on "Steve Davis Cabinets" only to find that it...musar — 02:25 PM |
philco predicta
|
Welcome to the Phorum, cgl18! I am not your resource for television repair, but lots of friendly help is available here...GarySP — 02:12 PM |
Model 70 Cabinet Trim
|
Welcome to the Phorum, musar! You can send Steve Davis a private message (PM). The site is at the top of the Home page...GarySP — 02:09 PM |
Model 70 Cabinet Trim
|
How do I contact him? The only contact information for him I could find when searching online was a telephone number th...musar — 10:38 AM |
philco predicta
|
Hello, good afternoon, I would like to ask what the possible problem could be if I don't have an image on the screen. I ...cgl18 — 10:19 AM |
Philco model 38 code 121 not receiving signal.
|
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM |
462ron
|
It’s on the bottom of the homepage of our Philcoradio.com homepage!
Ron462ron — 07:20 AM |
Who's Online
|
There are currently no members online. |
|

|