RCA 110K2 Unexpected project
Posts: 4,896
Threads: 54
Joined: Sep 2008
City: Sandwick, BC, CA
Ed;
I looked up your 110K2 in the 1937-42 U.S RCA red book and I was mistaken, unlike the Canadian RCA models for those years there is no wiring diagram or parts placement diagram. This would be one of the few occasions where the Philco manuals from the era are actually better. What you have out of Riders and Beitmans is pretty much what's in RCA's red book, so unless RCA sold a stand alone service folder for this set this is pretty much all that you are going to find.
Regards
Arran
Messages In This Thread
RE: RCA 110K2 Unexpected project - by Arran - 05-24-2018, 12:12 AM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Testing a speaker and output transformer Trutone A2-G
|
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now.
Have better volu...murf — 03:43 PM |
Philco model 38 code 121 not receiving signal.
|
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM |
Philco model 38 code 121 not receiving signal.
|
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM |
Philco model 38 code 121 not receiving signal.
|
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM |
Philco model 38 code 121 not receiving signal.
|
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM |
Philco model 38 code 121 not receiving signal.
|
I've reinstalled the coil. Now IT'S ALIVE!!!!!!
I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM |
Philco model 38 code 121 not receiving signal.
|
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM |
PT 6 chassis screws size???
|
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM |
Philco model 38 code 121 not receiving signal.
|
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM |
Philco model 38 code 121 not receiving signal.
|
Thankyou for the kind words sir.
I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM |
Who's Online
|
There are currently 2775 online users. [Complete List] » 3 Member(s) | 2772 Guest(s)
|
|
|

|