Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-7
#8

Ok how about pins 3,4, and 8 or the 6F6.
What happen when you apply a 470kc signal the cap of the IF amp and or the mixer?

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 02:50 PM
RE: Philco 38-7 - by Olskuul - 08-09-2018, 05:10 PM
RE: Philco 38-7 - by Radioroslyn - 08-09-2018, 06:08 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 09:47 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 05:40 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 06:09 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:03 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 05:30 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:48 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 06:11 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 06:55 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 07:23 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 09:22 PM
RE: Philco 38-7 - by Arran - 08-13-2018, 09:38 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:17 AM
RE: Philco 38-7 - by Ron Ramirez - 08-14-2018, 06:25 AM
RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 08:28 AM
RE: Philco 38-7 - by cpollock - 08-14-2018, 12:30 PM
RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 01:01 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:35 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 05:40 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 10:49 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 03:34 AM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 07:54 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Since you stated earlier, you have a console 38-7XX.  They also had a 38-7T (table), and 38-7CS (chairside).  A very nic...GarySP — 01:18 PM
Part numbers to model cross
That I wouldn't know, but sometimes the radio document itself shows one, same as the capacitor cans' etc pinouts.morzh — 12:46 PM
Part numbers to model cross
Thank you morzh, that is exactly what I was looking for. Now , is there some where that shows pinouts for Philco power ...Jim Dutridge — 11:37 AM
Restoration of the Canadian General Electric A-87
Thanks for your help Michael. In fact, this video is only an intermediate result. Later I had to apply another tinting l...RadioSvit — 09:01 AM
Restoration of the Canadian General Electric A-87
Great job on the cabinet. PS. In the US notation, "kenotron" refers to specific type of tubes; we call re...morzh — 08:24 AM
Part numbers to model cross
This document has at least some tables of models and parts used. Example: Choke 32-7572, used in 604 radio. Search f...morzh — 08:19 AM
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM

[-]
Who's Online
There are currently 1330 online users. [Complete List]
» 1 Member(s) | 1329 Guest(s)
Avatar

>