Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PHILCO 91 225 IDENTIFICATION
#15

>Is there a way that you are aware of, to restore it to what the original finish looked like?  If so, I would like to do that.
If it were mine I would remove it from the cabinet, give it a good clean w/something to remove any wax or oils. Then give it a coat or two of toned lacquer (med walnut) to diminish the brightness.

> Also, I just noticed the N3GTE...
When you post that you had a Kenwood something or other I did a little sleuthing and found your call. I was surprised that are calls are just a few letters off but I've had mine since 2/89. 1st licensed as a novice 30 yrs ago this month as KA3TSY and got the 'GTE call when I upgraded to Tech. It's nice and short on CW so I kept it.

>Next up, we are going to attempt redoing a 1940 RCA Victor model 110K. I hope that I'm permitted to say "RCA" in this forum... LOL
But of course just post under Other Radios. We are a nondiscriminatory Phorum[Image: http://philcoradio.com/phorum/images/smi..._angel.gif]


Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-06-2017, 09:58 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-06-2017, 10:28 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-06-2017, 11:33 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 05-07-2017, 08:36 AM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-07-2017, 10:37 AM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-08-2017, 05:20 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-08-2017, 07:51 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-05-2018, 07:02 PM
RE: PHILCO 91 225 IDENTIFICATION - by morzh - 09-05-2018, 08:33 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 09-05-2018, 10:34 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 11:29 AM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-06-2018, 06:50 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 09-06-2018, 07:03 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 07:16 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 09-06-2018, 09:37 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 09:41 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-07-2018, 01:46 PM
RE: PHILCO 91 225 IDENTIFICATION - by OldRestorer - 09-08-2018, 09:03 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Model 70 Cabinet Trim
Although I have not made any cabinets or cabinet parts for a couple of years, I still have some parts left over, includi...Steve Davis — 06:26 PM
philcorepairbench.com - shadow-meter
Thanks Ron.fenbach — 02:43 PM
Model 70 Cabinet Trim
Thank you, Gary. Before making my original post, I had clicked on "Steve Davis Cabinets" only to find that it...musar — 02:25 PM
philco predicta
Welcome to the Phorum, cgl18! I am not your resource for television repair, but lots of friendly help is available here...GarySP — 02:12 PM
Model 70 Cabinet Trim
Welcome to the Phorum, musar! You can send Steve Davis a private message (PM). The site is at the top of the Home page...GarySP — 02:09 PM
Model 70 Cabinet Trim
How do I contact him? The only contact information for him I could find when searching online was a telephone number th...musar — 10:38 AM
philco predicta
Hello, good afternoon, I would like to ask what the possible problem could be if I don't have an image on the screen. I ...cgl18 — 10:19 AM
Philco model 38 code 121 not receiving signal.
So one last question before I finish this radio. Regarding the speaker and output transformer. I salvaged the original o...Stormlord5500 — 09:31 AM
462ron
It’s on the bottom of the homepage of our Philcoradio.com homepage! Ron462ron — 07:20 AM
Model 70 Cabinet Trim
Steve might have some trim left. Not sure he is making anything.morzh — 06:12 AM

[-]
Who's Online
There are currently 551 online users. [Complete List]
» 2 Member(s) | 549 Guest(s)
AvatarAvatar

>