1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
41-608 code 122 Capacitor Questions
rdaskew
Junior Member
**
Posts: 5
Threads: 1
Joined: Sep 2018
City: Chicopee State, Province, Country: MA
#1

09-24-2018, 09:29 AM
Hi all, I'm new here and this is my first restoration, so just wanted to say thanks for any help you can give!

I've been recapping this Philco 41-608 and there are a couple of items on the schematic that I can't seem to identify or figure out how to replace.

Can anyone give me any guidance on #21 and #81?

I know that #21 is in a can on top of the chassis. How does the can remove and how do you replace what's in there?

And also read another thread that mentioned that #81 should be replaced with Y- Safety caps, but I can't seem to identify what items they actually correspond to on the actual chassis?
Find
« Next Oldest | Next Newest »


Messages In This Thread
41-608 code 122 Capacitor Questions - by rdaskew - 09-24-2018, 09:29 AM
RE: 41-608 code 122 Capacitor Questions - by sam - 09-25-2018, 01:47 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2135 online users. [Complete List]
» 1 Member(s) | 2134 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration