RCA 110K2 Unexpected project
Posts: 1,385
Threads: 45
Joined: Nov 2017
City: Menlo Park
State, Province, Country: CA
The first coat of oil dried up, leaving dull patches where it had coated bare wood. On Wednesday morning I found time to pass gently over the right side of the cabinet with 0000 wire wool, and rub in another coat of tung oil. Looking again this morning, it appears this approach is working nicely, a deep color and good finish is beginning to develop.
I have refinished a number of pieces of furniture this way, including our "Danish Modern" coffee table. This had been very neglected before we got to it, but (a lot of) TLC returned it to glory.
I don't hold with furniture that talks.
Messages In This Thread
RE: RCA 110K2 Unexpected project - by EdHolland - 10-12-2018, 01:19 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Testing a speaker and output transformer Trutone A2-G
|
You guy's are right on. I found a broken wire on the speaker plug that I replaced and all is well now.
Have better volu...murf — 03:43 PM |
Philco model 38 code 121 not receiving signal.
|
I need to get a vtvm. I think that little component tester is just more accurate. Plus it shows the inductance which is ...Stormlord5500 — 03:07 PM |
Philco model 38 code 121 not receiving signal.
|
I use a pair of Mastercraft brand DMMs from Canadian Tire, from what I read most of those DMMs use the same main chip re...Arran — 02:36 PM |
Philco model 38 code 121 not receiving signal.
|
Thank you sir. Yes I feel good and also relieved because this one's been weighing on me a bit.Stormlord5500 — 11:18 AM |
Philco model 38 code 121 not receiving signal.
|
It feels good don't it? Good luck on the rest.Paul Philco322 — 11:06 AM |
Philco model 38 code 121 not receiving signal.
|
I've reinstalled the coil. Now IT'S ALIVE!!!!!!
I fired up my TinySA on signal generator mode and set it to 1400Kc and ...Stormlord5500 — 11:01 AM |
Philco model 38 code 121 not receiving signal.
|
Yes, Walmart, right up there with Fluke.RodB — 11:00 AM |
PT 6 chassis screws size???
|
it certainly won't be metric! SAE threads were all that was known then. Take care, - GaryGarySP — 10:58 AM |
Philco model 38 code 121 not receiving signal.
|
I think this thing is way more accurate than my Walmart DMM. :DStormlord5500 — 08:19 AM |
Philco model 38 code 121 not receiving signal.
|
Thankyou for the kind words sir.
I double checked it with my component tester and it read 2.7 ohms at .02mH.Stormlord5500 — 08:14 AM |
Who's Online
|
There are currently 2762 online users. [Complete List] » 3 Member(s) | 2759 Guest(s)
|
|
|

|