Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 49-504
#4

Well I am stuck again I downloaded the schematic from Nostalgia Air and on the alignment page figure 7 it shows the dial cord layout but does not mention whether  the tuning condenser is closed or open when putting a new cord on. Also wonder why Philco used 2 dial strings on this because most all other table radios use one? The diagram is difficult to see exact layouts, I've tried everything????? Any help?


Messages In This Thread
Philco 49-504 - by Marko - 01-01-2019, 11:12 AM
RE: Philco 49-504 - by Radioroslyn - 01-01-2019, 02:34 PM
RE: Philco 49-504 - by Marko - 01-02-2019, 11:31 AM
RE: Philco 49-504 - by Marko - 01-08-2019, 12:16 PM
RE: Philco 49-504 - by sam - 01-08-2019, 01:04 PM
RE: Philco 49-504 - by KCMike - 01-08-2019, 04:21 PM
RE: Philco 49-504 - by Marko - 01-08-2019, 04:35 PM
RE: Philco 49-504 - by klondike98 - 01-08-2019, 07:32 PM
RE: Philco 49-504 - by KCMike - 01-08-2019, 07:37 PM
RE: Philco 49-504 - by klondike98 - 01-08-2019, 07:56 PM
RE: Philco 49-504 - by Marko - 01-08-2019, 08:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM

[-]
Who's Online
There are currently 1146 online users. [Complete List]
» 1 Member(s) | 1145 Guest(s)
Avatar

>