Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

112X Cabinet restoration
#32

It is likely that one of those is causing the pop on warm-up. You might try shuffling them. On my Panatrope a strong 1st audio is always noisy - or hum. So I just use a good one ~900 gm, no problem

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
112X Cabinet restoration - by rfeenstra - 12-31-2018, 01:07 AM
RE: 112X Cabinet restoration - by rfeenstra - 12-31-2018, 01:20 AM
RE: 112X Cabinet restoration - by Greggshere - 12-31-2018, 08:28 AM
RE: 112X Cabinet restoration - by Phlogiston - 12-31-2018, 11:36 AM
RE: 112X Cabinet restoration - by rfeenstra - 12-31-2018, 01:40 PM
RE: 112X Cabinet restoration - by rfeenstra - 12-31-2018, 01:43 PM
RE: 112X Cabinet restoration - by Phlogiston - 12-31-2018, 02:31 PM
RE: 112X Cabinet restoration - by rfeenstra - 12-31-2018, 05:15 PM
RE: 112X Cabinet restoration - by Phlogiston - 12-31-2018, 05:24 PM
RE: 112X Cabinet restoration - by Arran - 12-31-2018, 05:53 PM
RE: 112X Cabinet restoration - by rfeenstra - 12-31-2018, 07:06 PM
RE: 112X Cabinet restoration - by OldRestorer - 01-02-2019, 08:04 AM
RE: 112X Cabinet restoration - by rfeenstra - 01-02-2019, 12:29 PM
RE: 112X Cabinet restoration - by Phlogiston - 01-02-2019, 01:12 PM
RE: 112X Cabinet restoration - by rfeenstra - 01-02-2019, 03:23 PM
RE: 112X Cabinet restoration - by Greggshere - 01-02-2019, 06:37 PM
RE: 112X Cabinet restoration - by rfeenstra - 01-02-2019, 08:38 PM
RE: 112X Cabinet restoration - by rfeenstra - 01-03-2019, 11:26 PM
RE: 112X Cabinet restoration - by rfeenstra - 01-10-2019, 12:07 AM
RE: 112X Cabinet restoration - by rfeenstra - 01-10-2019, 02:32 AM
RE: 112X Cabinet restoration - by Greggshere - 04-14-2019, 09:16 AM
RE: 112X Cabinet restoration - by Phlogiston - 04-14-2019, 10:58 AM
RE: 112X Cabinet restoration - by rfeenstra - 04-14-2019, 02:03 PM
RE: 112X Cabinet restoration - by klondike98 - 04-14-2019, 06:51 PM
RE: 112X Cabinet restoration - by rfeenstra - 04-14-2019, 11:31 PM
RE: 112X Cabinet restoration - by Phlogiston - 04-15-2019, 10:28 AM
RE: 112X Cabinet restoration - by mark123 - 04-15-2019, 01:43 PM
RE: 112X Cabinet restoration - by EdHolland - 04-15-2019, 02:35 PM
RE: 112X Cabinet restoration - by rfeenstra - 04-15-2019, 07:39 PM
RE: 112X Cabinet restoration - by rfeenstra - 04-15-2019, 07:46 PM
RE: 112X Cabinet restoration - by Phlogiston - 04-16-2019, 10:30 AM



Users browsing this thread:
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2283 online users. [Complete List]
» 4 Member(s) | 2279 Guest(s)
AvatarAvatarAvatarAvatar

>