1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
77 low volume
rjm
Member
***
Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern State, Province, Country: Tennessee
#3

02-15-2006, 02:17 PM
Hi Chuck, Thanks for the reply. #2 from volume center tap to gnd. 20.9 ohms, gnd. to tab for coil #5- 6.2ohms. Coil #5 center tap 6.2 and 6.1 ohms. Coil #9- 45.7, 6.3, 1.5 ohms. Coil #10- 48.5, 6.2, 1.5 ohms. B+ voltage on plates 154. All capacitors and out of tolerance resistors were replaced. Also before replacing anything there was a wire bridge on the bc resistor connecting H & J. I removed it since I could not find it on any schematics or updates. The resistor tests good between H & J 2,054ohms. specs. 2,000 ohms. Also a 24k dog bone resistor was in parallel with resistor #12 a 100k. I also remove it. Both seem to have been added a while back. Thanks, Richard
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
77 low volume - by rjm - 02-15-2006, 01:46 AM
[No subject] - by Chuck Schwark - 02-15-2006, 09:59 AM
[No subject] - by rjm - 02-15-2006, 02:17 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
Yes, 57 is an electrolytic cap that should be 12 mfd 400 volts according to the parts list from the Phorum library schem...RodB — 06:01 PM
Philco 42-345 Restoration/Repair
Looks like if I am reading it correctly it looks like the silver capacitor#57 that appears to be a replacement is of a l...osanders0311 — 05:09 PM
Philco model 38 code 121 not receiving signal.
Thanks Arran. Yeah this plastic is pretty thin. It's a little thinner than the original stuff. It kinda reminds me of p...Stormlord5500 — 04:37 PM
Testing a speaker and output transformer Trutone A2-G
The equivalent of one short turn is basically the same as that of a shorted load. If it is the primary's turn, then the ...morzh — 03:53 PM
Testing a speaker and output transformer Trutone A2-G
I've never had an output transformer become shorted, the failure mode is usually an open primary, or in a center tapped ...Arran — 03:52 PM
Philco model 38 code 121 not receiving signal.
As long as the plastic sheeting isn't too thick, I think that the thickness of photographic film would be just about rig...Arran — 03:19 PM
Philco model 38 code 121 not receiving signal.
Well why not! :lol:Stormlord5500 — 03:14 PM
Philco model 38 code 121 not receiving signal.
Good luck next thing you know you will be winding coils just for the fun of it. DavidDavid — 11:29 AM
Testing a speaker and output transformer Trutone A2-G
morzh Short-circuited turns can be considered as a half-dead transformer. But on this case transformer will hot and s...Vlad95 — 11:01 AM
Testing a speaker and output transformer Trutone A2-G
I am not sure how a transformer could be weak. It could be inadequate, but only when you replace the original with somet...morzh — 09:56 AM

[-]
Who's Online
There are currently 2184 online users. [Complete List]
» 1 Member(s) | 2183 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration